Search RAC Drive for news, reviews, advice and more
Don’t worry, a lot of us need reminding about what our various lights do and when to use them. Aftermarket Tail Lights
Here’s our helpful guide to explain everything you need to know about car lights.
There are several lights on our cars: indicators that double up as hazard lights, tail lights that sit next to brake lights, and headlights that we can set to different modes.
Read on to find out what lights you’ll find on your vehicle and what they do.
Dipped headlights are the most commonly used headlights; brighter than sidelights, but not as bright as full beam headlights.
They get their name as they are angled downwards, towards the road. The switch to turn them on is usually found on a dashboard dial or twisted indicator stalk, although many newer cars have running lights that work without input from the driver.
The highway code says, "You must use headlights when visibility is seriously reduced", with ‘seriously reduced’ defined as when you are able to see less than 100m in front of you.
This means they should be turned on at night-time and during bad weather.
You MUST NOT use any lights in a way which would dazzle or cause discomfort to other road users, including pedestrians, cyclists and horse riders.
You should also use dipped headlights, or dim-dip if fitted, at night in built-up areas and in dull daytime weather, to ensure that you can be seen.
Full beam headlights are the brightest type of headlight on normal vehicles.
They are angled higher than dipped headlights, allowing you to see more of the road, and are sometimes known as high beams.
The switch to turn them on is usually found near the switch for dipped headlights and they may use a different set of bulbs.
You should only use full beam headlights on unlit stretches of road at night.
When meeting oncoming traffic (including cyclists or pedestrians), following another vehicle, or driving on left-turning bends, you must turn off full beam headlights as they can often be dazzling and may cause accidents.
Fog lights are designed to cut through fog and mist, unlike full beam lights that are reflected by fog.
They usually come in two sets, front and back, with the switches coloured coded: amber for rear fog lights and green for front fog lights.
In most cars you’ll need to turn your dipped headlights on before pressing or twisting the fog light switch.
You should only use your fog lights when visibility is below 100 metres. To use a classic British measurement putting it in perspective: that’s roughly the length of a football pitch.
It’s important not to use your fog lights when visibility is better than that, as you risk dazzling other drivers.
Read more: Driving in fog - when to use fog lights
Your hazard lights can be seen at all corners of your car - they’re the lights usually used as your indicators.
The blinking amber lights are used to warn other drivers of danger or obstructions on the road, and the dashboard button is indicated with a triangle shape as shown above.
You should only use your hazard lights if your vehicle is stationary, to warn others that you’re causing a temporary obstruction.
This may happen when you’ve had an accident, broken down or been forced to stop by an obstruction.
You may also use your hazard lights if you are on a motorway and there is an obstruction up ahead that you need to warn other drivers about.
Indicators take up the same position as your hazard warning lights, visible on all corners of your car.
The blinking amber lights are turned on and off down one side of your car using your indicator stalk. They also automatically turn off once you straighten your wheels after making a turn.
If you've passed your test you definitely shouldn't need to ask this!
You should use indicators to show other road users and pedestrians where you intend to turn. This includes roundabouts, pulling away, overtaking and changing lanes.
Make sure you don’t leave it too late, or turn them on too early, as others might think you’re taking an earlier turning.
Car sidelights, or parking lights as they are sometimes known, are usually found in the headlamp unit in the front corners of your car.
Sidelights aren’t as bright as headlights, so are used by drivers to make themselves visible to traffic during times when it’s not dark enough for main lights.
The switch to turn them on is usually found on a dashboard dial or twisted indicator stalk.
The Highway Code says that all vehicles must display parking lights or sidelights when parked on a road (or lay-by) with a speed limit over 30mph. They are designed to be left on for long periods of time when you leave your car and shouldn’t drain your battery.
If the road has a speed limit of 30mph or less, you don’t need to use your sidelights, as long as:
Sidelights must also be switched on if your vehicle, for unavoidable reasons, is parked on any road in fog.
Read more: Parking lights – what are they and when should I use them?
Tail lights are red and found on the back of your car. They’re turned on/off at the same time as your headlights.
So, whether you manually turn on your headlights or they work automatically, they will illuminate either way.
Complete peace of mind from just £7.40 a month for new customers.
* New Customers only. Max 33% applies to Extra and Complete cover for 1 vehicle or 1 person. Ends 16.01.24, 7am.
Brake lights are also red and are located near your tail lights. They illuminate to show other drivers that you’ve applied your brakes and are slowing down.
You should make sure they’re kept clean and working at all times. Aside from the safety risks involved, a faulty brake light could see you pulled over by the police and given:
In serious circumstances your car could even be taken off the road immediately.
With cars changing like never before, it’s no surprise that their lights are also evolving.
As manufacturers consider the environmental impact of their work, energy efficient solutions have become more popular on our vehicles. Advances in technology have given us three common bulb types:
Halogen lights are the most popular kind on our roads today. They use a combination of gases - usually nitrogen and argon – and a tungsten filament in a glass tube.
Once the filament is heated, light is produced. They are cheap and easy to replace, but have fallen out of favour in recent years.
A standard Halogen bulb will produce 1300 Lumen, a good level of light but dimmer than other options.
The unnecessary and unused heat generated by halogen makes it incredibly inefficient and as light isn’t focused, illumination of the road isn’t as bright as it could be.
LED stands for ‘light emitting diodes’ and is currently the most energy efficient system widely available.
With a short rise time – the time it takes to turn on – they work over 250 times faster than halogen, making it the perfect system for brake and indicator lights.
The long-lasting light source is small and can be arranged into a variety of designs, which gives manufacturers a lot more flexibility with their designs. These directional lights are brighter than halogen bulbs of the same wattage as well.
LEDs produce a small amount of heat at the emitter when electricity passes through and require cooling systems to avoid damage to nearby cables. Cooling systems are generally positioned in the engine bay.
With a number of human-made components, LEDs are expensive in comparison to halogen bulbs.
Xenon high intensity discharge (HID) headlights heat gases and rare metals to generate a bright white or blue glow.
They are up to three times brighter than halogen bulbs with the same wattage. HID lamps need more power to start up than halogen but operate at a much lower power usage, with a greater lifespan.
HID headlights are very distinctive when you see them out on the road, but they’ve failed to become an industry standard for a few reasons. Among these are the cost of the rare metals needed to produce them, their uncontrolled brightness which often causes glare for other drivers, and the time they take to reach full brightness.
There you have it: more information about car lights than you'll probably ever need. Want to make sure yours all work? Here's how:
Running a car isn’t cheap, but there are some easy things you can do to keep your costs down. Get these tips and more useful driving articles sent straight to your inbox now.
If you are looking to replace the bulbs within any of your car's lights, we stock a wide range over at the RAC Shop.
Get the latest news, reviews and offers to help keep your motoring costs down.
By clicking subscribe you are adhering to our terms and conditions. Please see our privacy policy for more details.
Complete peace of mind from just £7.40 a month for new customers.
* New Customers only. Max 33% applies to Extra and Complete cover for 1 vehicle or 1 person. Ends 16.01.24, 7am.
Get the latest news, advice, reviews and offers to help keep your motoring costs down.
Taillights By clicking subscribe you are adhering to our terms and conditions. Please see our privacy policy for more details.